Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
zh-tw:system_information_portal_server [2013/06/18 08:07] Coco |
zh-tw:system_information_portal_server [2013/06/18 08:18] Coco |
||
---|---|---|---|
Line 38: | Line 38: | ||
=== 故障排除 === | === 故障排除 === | ||
- | - If automatic port mapping fails, set up port forwarding manually. Redirect incoming traffic on port 10080 to port 80 on your network drive. | + | - 如果自動連接埠轉發失敗,請使用手動設置連接埠轉發,Router 連接埠轉發(80埠->10080埠)。 |
- | - If remote login fails and port forwarding was not successful, on your router, add the IP address of your network drive to the DMZ zone. | + | - 如果遠程登錄失敗,您的路由器轉發沒有成功,請將私有雲 IP 地址放置到 Router 的 DMZ 內。 |
- | - If there is a conflict with the default port 10080 or this port is blocked on the network you are trying to connect from, change it to another port number. | + | - 如果默認的映射埠號 10080 埠有衝突 或這個埠號被封鎖,請將其更改為另一個埠號。 |
- | - If you see that after the login, the URL still shows the device name or MAC address instead of the internal or external IP address, apply the settings for the portal server once more. If necessary, change the port number for the mapping port to another number. | + | - 如果你看到連線後網址仍然顯示的是設備名稱,而不是內部或外部的IP地址或MAC地址,請在「入口網站」設置中在按下**套用**一次,看看 **映射地址** 是否有變更,使用變更的 **映射地址** 重新連線一次。如果有必要,更改"映射埠號"。 |
- | - If the "Connection Status" shows **Unconnected**, login to your network router and make sure that the TCP port 9000 is not blocked by the firewall. | + | - 如果“連接狀態”顯示未連接,請進入到你的路由器中,並確保防火牆的TCP端口9000沒有阻檔。 |
===== dyn.com ===== | ===== dyn.com ===== |