This is an old revision of the document!

MyCloud Duo

The MyCloud Duo is designed for two desktop 3.5“ SATA hard drives. It provides safe and secure network storage plus the ability to easily share your digital content with family and friends. Stream content within your local network to any available UPnP-AV and DLNA device (e.g. PS3, iTunes, Windows 7, etc.). Remotely access your files through any internet connected computer or through our free iPhone, iPad and Android apps.

  • Dual-core 750MHz (SOC)
  • 128MB DDR2 SDRAM
  • 256MB NAND flash
Internal hard drive(s)
  • 3.5” SATA-I, SATA-II or SATA-III hard drives
  • Capacity 80GB - 3TB (supports large volumes in excess of 2TB)
  • XFS file system
Front I/O
  • 1 x Power button
  • 5 x Status LEDs (system, data access, error, copy)
  • 1 x Copy button
  • 1 x USB 2.0 host connector
Rear I/O
  • 1 x Power receptacle
  • 1 x RJ45 connector (10/100/1000) with two LEDs for link and activity
  • 1 x USB 2.0 host connector
  • 1 x Reset button

Front View

Power button (blue when turned on)
  • Blue = System is running and ready
  • Flashing blue = System is starting up or shutting down
Flashing green = Data access
Red = System error (system is unable to start up)
  • Orange = USB drive connected (front port only)
  • Flashing orange = File copy from USB drive to NAS (front port only)
Copy USB copy button
USB 2.0 host port
Press and hold the copy button for one second to copy the files from the USB drive on the front port to the PUBLIC folder on the network drive.

Rear View

USB 2.0 host port
Gigabit Ethernet port
DC +12V Power receptacle
Reset System reset button
Security lock slot
To reset the configurations (e.g. admin password, DHCP settings, preferences, etc.), make sure the power is ON and the system is running. Press and hold the Reset button for 12 seconds and then release it.

Power ON/OFF Procedure

Connect the power supply to your device first and only then plug it into the wall outlet. The system starts up automatically as soon as you plug in the power supply. It takes about 1-2 minutes for the device to go online but the blue system LED will indicate when the system is ready.

To safely turn off the device, press and hold the power button for about 4 seconds until the red LED starts flashing. The system will then shut down all services and about 20 seconds later, it will power down.

If for some reason the system is unresponsive, press and hold the power button for 6 seconds to forcefully shut down the system and cut off the power.

If the device is not in use for long periods of time, we recommend that you turn off the device and remove the power supply from the wall socket.

HDD Installation

Remove the screw at the bottom of the case and lift the front panel upward and away from the housing to remove it.

Install the hard drives as illustrated below with the top of the drives, where the label is located, facing each other. Push the drives lightly into place and then replace the front panel. Mount the front panel and the drives by fastening the screws at the bottom of the case.


AKiTiO MyCloud eManual
for iPad, Nook, Sony Reader, etc.

ePub format